Hand Crafted Custom Teardrop Trailers
The "Urban Refugee" Teardrop Trailer
- 5x8ft standard layout teardrop trailer.
- 11 feet overall length (ball to bumper)
- 6.5 feet overall width (outside of fender to outside of fender)
- Fully welded 2x2x1.88 HSS steel frame (Trailer height 18”)
- 32 x 9 in Steel Trailer Fender (square)
- L.E.D oval Tail lights with 3/4” L.E.D clearance lights (in frame wiring)
- 2000 lbs independent Torsion Axle
- 3/4 inch cabinet grade plywood construction.
- All aluminum trim in both galley and cabin (secured with Stainless Steel pan head screws)
- Varathane premium wood stain (colour undetermined)
- Indoor/Outdoor Carpet floor, ceiling, headboard and footboard.
- 26” x 36” door on passenger side, black trim, tinted glass sliders, screens
- 23” x 23” window driver side, black trim, tinted glass sliders, screens
- 110 volt ground fault circuit interrupter outlet in galley with additional outlet in cabin
- USB charging port and 12 volt port in both cabin and galley
- L.E.D lighting in cabin (two at front and two at back)
- L.E.D lighting in galley (one on hatch and one under counter)
- Roughed in solar with 30 amp charge controller installed in galley
- Spray foam insulation in roof cavity and in rear hatch
- polished checker plate clad sides
- 14" wheels (white) and ST205/75R14 tires
- Three speed fan cabin fan
- 1 deep cycle battery
Standard features
Baddog trailer frame
Fully welded 2x2x1/8 HSS with load bearing fender mounts. L.E.D tail lights and clearance lights with in frame wiring.
Cabinet grade 3/4" plywood construction
Varathane stained panels with sprayed clear top coat. ( Custom stain colors available)
Polished aluminum checker plate side cladding
Powder coating options available
Indoor outdoor carpet on the floor, headboard and footboard.
Colour options are limited to availability
All aluminum trim in both galley and cabin.
Secured with 3/4 stainless steel pan head screws
L.E.D lighting In both cabin and galley
Four L.E.D lights total in the cabin and the galley has one on the hatch and counter lights
Our standard steel frame is built using 2x3 inch HSS (Hollow Structural Steel) for the A- frame style hitch assembly and 2x2 inch HSS for the main trailer/cabin frame. Sporting Independent torsion axels, L.E.D clearance/tail lights . Construction for the sleeper and galley we use 3/4” cabinet grade plywood and industrial grade Aluminum. Also included In both the sleeper and galley are 110 Volt outlets (Shore Power) USB ports and a 12V auxiliary power outlets. L.E.D camper lighting as follows: Four swivel lights inside the sleeper and two stationary lights inside rear hatch. Outside L.E.D area lights are on both driver and passenger side and are functioned from inside the cabin. Solar panel wiring is “Roughed in”for easy installation at a later time. Below you will find a curated list of options we offer. To receive a custom quote just complete this PDF form and e-mail to baddogin@live.ca
